All of the devices used in this document started with a cleared (default) configuration. The information in this document was created from the devices in a specific lab environment. The information in this document is based on these software and hardware versions:Ĭisco Router 3640 with Cisco IOS® Software Release 12.4 There are no specific requirements for this document. This IP addressing scheme helps you to troubleshoot your network. Note: In order to avoid the overlapping of IP addresses in the network, assign the entirely different pool of IP addresses to the VPN Client (for example, 10.x.x.x, 172.16.x.x, .x). Refer to PIX/ASA 7.x and VPN Client for Public Internet VPN on a Stick Configuration Example in order to complete a similar configuration on a central site PIX Firewall. This allows the Internet traffic to be port address translated (PATed) to the outside world. In order to achieve this, configure the policy map in the router to point all the VPN traffic (Cisco VPN Client) to a loopback interface. This setup applies to a specific case where the router, without enabling split tunneling, and Mobile users (Cisco VPN Client) can access the Internet via the central site router. This document describes how to set up a central site router to perform IPsec traffic on a stick.
0 kommentar(er)
